What To Know
- This pump is responsible for circulating water throughout the dishwasher during the wash cycle, and if it’s not working properly, it can cause your dishes to come out dirty or even damage the dishwasher itself.
- In this blog post, we’ll show you how to remove a KitchenAid dishwasher circulation pump so you can replace it with a new one.
- Once the new circulation pump is installed, plug the dishwasher back in and turn on the water supply.
If your KitchenAid dishwasher is giving you trouble, one possible culprit could be a faulty circulation pump. This pump is responsible for circulating water throughout the dishwasher during the wash cycle, and if it’s not working properly, it can cause your dishes to come out dirty or even damage the dishwasher itself.
In this blog post, we’ll show you how to remove a KitchenAid dishwasher circulation pump so you can replace it with a new one. We’ll provide step-by-step instructions with photos, so you can follow along easily.
Tools and Materials You’ll Need
Before you start, you’ll need to gather a few tools and materials:
- Screwdriver
- Pliers
- Bucket or bowl
- Rags
- New circulation pump
Safety Precautions
Before you begin working on your dishwasher, be sure to take the following safety precautions:
- Unplug the dishwasher from the power outlet.
- Turn off the water supply to the dishwasher.
- Wear gloves and safety glasses.
Step-by-Step Instructions
1. Remove the Lower Dish Rack
Start by removing the lower dish rack. This will give you access to the circulation pump.
2. Locate the Circulation Pump
The circulation pump is located at the bottom of the dishwasher, near the center. It’s usually a black or gray plastic cylinder with a motor attached to it.
3. Disconnect the Wires
Use a screwdriver to disconnect the wires from the circulation pump. Be careful not to damage the wires.
4. Remove the Hoses
Use pliers to remove the hoses from the circulation pump. Be careful not to spill any water.
5. Remove the Circulation Pump
Once the wires and hoses are disconnected, you can remove the circulation pump by pulling it straight up.
6. Clean the Area
Before installing the new circulation pump, take a few minutes to clean the area where the old pump was located. This will help prevent any debris from getting into the new pump.
7. Install the New Circulation Pump
Now you can install the new circulation pump. Simply insert it into the hole where the old pump was located and connect the wires and hoses.
8. Test the Dishwasher
Once the new circulation pump is installed, plug the dishwasher back in and turn on the water supply. Then, run a test cycle to make sure the pump is working properly.
Troubleshooting
If you’re having trouble removing the circulation pump, here are a few troubleshooting tips:
- Make sure that you’ve disconnected all of the wires and hoses from the pump.
- If the pump is stuck, try using a pair of pliers to gently pry it loose.
- If you’re still having trouble, you may need to call a qualified appliance repair technician.
Wrapping Up
Removing a KitchenAid dishwasher circulation pump is a relatively easy task that can be completed in about an hour. By following the steps outlined in this blog post, you can save yourself the cost of calling a repair technician.
